This release provides the functionality detailed below:

• Support for 32GB, 64GB and 128GB solid state drive modules.
• Enhanced AM/FM radio reception. (applicable only to ICOP DVRs manufactured after May 2010, with serial numbers greater than D1050001)

Previous Firmware Upgrades:

M0155

• Support for new 20/20-W LCD which provides a better viewing angle and correct aspect ratio.
• The M0155 firmware is backward compatible with the existing 20/20-W units with the previous LCD.
• Corrected a hardware interrupt timing issue when recording.

M0140

• Support for multiple languages (English, Spanish and Arabic).
• Fully implemented feature set to support the ICOP Model 20/20 VISION DVR.
• If a trigger event occurs during a wireless upload, the upload will be aborted and a recording started.
• Enhanced the ability to set radio stations using the DVR Setting Tool to accommodate international settings.
• Corrected the system to allow the external microphone audio to be played inside the car after it has gone out of range and come back in, or the external microphone is muted and subsequently un-muted.
• Enhanced the front facing camera focusing algorithm.
• Default the backseat camera to black and white.
• Use GPS speed to compare against the speed trigger.
• Auto power off the unit if powered on with the front panel open and no action is taken

M0136

• Support for WC-2000 wireless upload communication
• Configuration setting of auto power down that can be configured from 15 minutes up to 2 hours
• Inclusion of an “Auto login” feature (through supervisor setup)
• Support of auxiliary inputs for Start, Stop, Mark control using new externally control unit
• Inclusion of a “wireless timeout” to specify the maximum amount of time for a wireless upload session
• Change of GPS position representation to “minutes.decimal minutes” for 911 compatibility
• Provides user feedback if HDDM from ICOP Model 20/20 is inserted into an ICOP Model 20/20-W
• Increased resiliency for writing data to the HDDM under extremely high operating temperature
• Updates to speed monitoring algorithm to closer track actual vehicle speed
• Increased robustness during firmware updates and user operation
• Requires user login before activation of AM/FM radio

Make sure to read the Product Upgrade Announcement prior beginning the upgrade process:

Product Upgrade Announcement
Firmware 0170 for ICOP Model 20/20-W and ICOP 20/20 VISION (ONLY)

CLICK HERE TO CONTINUE TO THE 0170 FIRMWARE DOWNLOAD REQUEST FORM.